Filter
Top Products
199
Menu: Menu Description Tables
Menu
MIC/AUDIO2
Items/
Data Saved
Adjustable
Range
Remarks
FRONT MIC
POWER
ON
OFF
Select the phantom power supply for the
front microphone.
–CUF–
REAR MIC
POWER
ON
OFF
Select the phantom power supply for the
rear microphone.
When “OFF” is selected, no phantom
power is supplied even if the LINE/MIC/
+48V selector switch is set to [+48V].
–CUF–
MONITOR
SELECT
STEREO
MIX
When the MONITOR select switch is set
to [ST] (stereo), select the signal format
for the monitor output.
–CUF–
FRONT MIC
LEVEL
–40dB
–50dB
Select the front microphone input level.
–CUF–
REAR MIC CH1
LVL
–50dB
–60dB
Select the rear microphone input level.
–CUF–
REAR MIC CH2
LVL
–50dB
–60dB
Select the rear microphone input level.
–CUF–
REAR LINE IN
LVL
0dB
+4dB
–3dB
Select the rear line input level.
–CUF–
AUDIO OUT LVL 0dB
+4dB
–3dB
Select the audio output level.
–CUF–
HEADROOM 18dB
20dB
Set the headroom (standard level).
–CUF–
WIRELESS
WARN
ON
OFF
Select whether or not to enable the
alarm to trigger for poor wireless receiver
reception.
–CUF–
WIRELESS
TYPE
SINGLE
DUAL
Select the type of wireless receiver.
SINGLE:
Select a single channel wireless
receiver.
DUAL: Select a 2-channel wireless
receiver.
–CUF–
TC/UB
Items/
Data Saved
Adjustable
Range
Remarks
TC MODE DF
NDF
Set the time code mode.
DF: Drop frame.
NDF: Non drop frame.
Note
When the unit operates at 50 Hz or in
24P or 24PA mode, the non-drop frame
is always used.
–CUF–
UB MODE USER
TIME
DATE
EXT
TCG
FRM RATE
REGEN
Select the user bits mode.
USER: Select UB value set in the LCD
section.
TIME: Select local time (hours,
minutes, seconds).
DATE: Select local date and time (2 last
digits of year, month, date, time).
EXT: The user bits input to the TC IN
connector are recorded.
If reading fails, USER value is
retained.
TCG: TCG value enters UB.
FRM RATE:
Select the shooting information
(e.g. frame rate) for the camera.
For more information, see
[Frame rate information
recorded in user bits] (page 66).
When clips recorded in native
mode are played back, the frame
rate information recorded in
users bits in the VAUX area is
output.
REGEN:
Read out value stored in the
card and record value
continuously.
–CUF–
AJ-HPX3700G-VQT1V68_eng.book 199 ページ ２００８年１０月１５日 水曜日 午後６時３８分