Filter
Top Products
Operating Instructions
36
Basic
(1) Network (IPv4) Configures the IPv4 network settings to connect the
camera to the network (see page 38).
(2) Network (IPv6) Configures the IPv6 network settings to connect the
camera to the network (see page 42).
(3) IPsec Enables IPsec (Transport or Tunnel mode) (see page 46).
(4) UPnP Enables automatic port forwarding or shortcut to the
camera (see page 56).
(5) Viewnetcam.
com
Registers with the Viewnetcam.com service (see page 58).
(6) Date and Time Sets the date and time, automatic time adjustment and
adjust clock for daylight saving time settings (see page 60).
(7) Camera Sets camera name, white balance, pan/tilt range, return to
specified position and color night view settings (see page
62).
(8) Audio Sets output, volume, PC audio input timeout, input, camera
microphone sensitivity and mute during pan/tilt settings
(see page 66).
Account
(9) Administrator
*1
*1
If you change [Administrator], [General User], or [Multi-Camera Setup page] settings,
changes will not be applied to the video (Motion JPEG) viewers. Restart the camera to make
changes applied to all video viewers.
Sets authentication setting and administrator security (user
name and password) (see page 68).
(10) General User
*1
Sets general user security (user name and password) and
general user's access level (see page 72).
Advanced
(11) Image Display Sets resolution, image quality and refresh interval of Single
Camera and Multi-Camera page, time stamp setting, and
language (see page 74).
(12) Multi-Camera
*1
Sets the camera IP address or host name, camera name on
the Multi-Camera page (maximum 12 cameras) (see page
76).