Filter
Top Products
Operating Instructions
92
7. Set the image buffer frequencies, and click [Next>].
Note
Due to the network environment, object, number of accesses, enabling IPsec,
SD memory recording, the camera may not record the numbers of images as
you set. In this case, set the image buffer frequencies longer. For the SD
memory recording, 1 image per second setting is recommended.
• Clicking [<Back] takes you back to the previous page.
• Clicking [Cancel] takes you back to the Image Buffer/Transfer page
without saving changes.
Setting Description
Enable Pre-
trigger Image
Buffer
• Check the box to enable the setting. The camera buffers or
transfers the image right before the alarm signal is
detected.
• Set an interval, number of images to buffer and total
number. The buffered images may not match the total
number due to memory capacity, image resolution, image
quality or what object you view.
Enable Post-
trigger Image
Buffer
• Check the box to enable the setting. The camera buffers or
transfers the image right after the alarm signal is detected.
• Set an interval, number of images to buffer and total
number. The buffered images may not match the total
number due to memory capacity, image resolution, image
quality or what object you view.