Filter
Top Products
Operating Instructions
154
3.1.8 Resetting the Camera to Factory Default
All camera settings are reset to factory default directly after the Execute button is
clicked.
1. Click [Reset to Factory Default] on the Maintenance page.
2. Click [Execute].
• The indicator blinks orange, and then turns off for 10 seconds.
• All camera settings (user name, password, IP address, subnet mask etc.)
are reset to factory default.
• If the camera is reset to factory default, the network connection mode
changes to [Automatic Setup]. Reconfigure the camera seeing Getting
Started.
Note
• The internal clock will not be reset, but the time format will return to AM/
PM mode (see page
78). Set it again.
• See page 164—page 172 for default settings.
• Pressing the FACTORY DEFAULT RESET button resets the camera to the
factory default (see page
161).
• All buffered images on the internal memory are deleted when resetting the
camera to factory default. The buffered images on the SD memory card
are not deleted.
• The reset operation takes about 1 minute.
• Do not turn off the camera during the reset operation.
• If the camera is restarted, all alarm logs are deleted.