Filter
Top Products
Operating Instructions
57
Static Setup
You can assign a static IPv6 address to the camera. If you select [No] at the
Allow Access from the Internet, the camera can be accessed only from the
LAN that has an same IPv6 prefix as the camera.
• Clicking [Cancel] takes you back to the previous page without saving
changes.
4. Click [Save] when finished.
• New settings are saved.
• When finished, the following page is displayed.
Note
The current network settings are shown on the Status page in the Maintenance
section (see page
146).
5. Click [Restart].
• The camera restarts, and the Top page is displayed.