Filter
Top Products
11 Configure the alarm settings [Alarm]
The settings relating to alarm occurrences such as settings for the alarm action at an alarm occurrence, the
VMD area settings, and the alarm occurrence notification can be configured on this page.
The “Alarm” page has 3 tabs; the [Alarm] tab, the [VMD area] tab and the [Notification] tab.
11.1 Configure the settings relating to the alarm
action [Alarm]
Click the [Alarm] tab on the “Alarm” page. (®page 34, page 35)
The settings relating to the alarm can be configured in this section. Refer to page 80 and page 82 for further
information about the settings relating to the alarm images and the alarm output terminal.
Alarm
[Terminal 1]
VT164W
VT164W
VT164
VT164
Determine how to use terminal 1.
• Off: Not used.
• Alarm input: Receives alarms.
– Close: An alarm is detected when the terminal status is changed to “On”.
– Open: An alarm is detected when the terminal status is changed to “Off”.
• Default: Off
[Terminal 2]
VT164W
VT164W
VT164
VT164
Determine how to use terminal 2.
• Off: Not used.
• Alarm input: Receives alarms.
– Close: An alarm is detected when the terminal status is changed to “On”.
– Open: An alarm is detected when the terminal status is changed to “Off”.
• Alarm output: Alarm output will be carried out according to the settings for “Alarm output terminal
setup” (®page 82).
• Default: Off
Operating Instructions 77
11 Configure the alarm settings [Alarm]