Filter
Top Products
148
LSQT1011
Indications
Others
It is possible that the system cannot complete writing of a file normally when, for example, power is
turned off for some reason during recording or editing.
If faulty management information is found when a disc is accessed, the following message may
appear. Be sure to follow the messages. (Repairing may take time depending on the error.)
≥ When you repair the disc, use a battery with
sufficient battery power or the AC adaptor.
≥ Depending on the condition of the data, it may not
be possible to completely repair the data.
≥ If the disc is removed without it being repaired, you
will no longer be able to playback the scenes
recorded before the power went off.
≥ Do not repair a disc that has been recorded on
another device. This may cause the loss of data or
the disc.
CARD FULL.
The SD card is full so no further data can be recorded. Delete
unnecessary files (l 94) or insert a new SD card.
PUSH THE RESET
SWITCH.
An irregularity in the unit has been detected. Press the RESET
button to restart the unit. (l 155)
CHANGE TO MANUAL
MODE.
You are attempting to use a function that cannot be used
simultaneously.
CANCEL MAGICPIX MODE.
TURN OFF POWER LCD.
CANNOT SET.
With DVD-RW (Video format) and DVD-R, if the number of
dates displayed becomes 99 when [PLAY MODE] is set to
[BY DATE], you cannot change the aspect setting from 16:9 to
4:3 and vice versa.
CHANGE MODE TO USE
USB.
The USB cable is connected in the recording mode.
DISCONNECT USB
CABLE.
You are attempting to turn the mode dial with the USB cable
connected to the unit.
The unit’s power cannot be turned off when the unit is
connected to the computer.
The unit cannot correctly establish the connection to the
computer or printer. Disconnect and then reconnect the USB
cable or check the [USB FUNCTION] setting on this unit.
About recovery
DISC ERROR HAS OCCURRED. REPAIR DISC NOW?
D250&300(P_PC)eng.book 148 ページ ２００６年１月２０日 金曜日 午後２時３分