Filter
Top Products
46
LSQT1011
Setup
Setting date and time
∫ Changing the date and time display style
Press the MENU button, then select [ SETUP] # [DATE/
TIME] # desired display style and press the joystick.
≥ You can also show or change the date and time display by
repeatedly pressing the DATE/TIME button on the remote control.
≥ The recording time is not displayed in disc playback mode.
∫ Changing the display style
Press the MENU button, then select [ SETUP] #
[DATEFORMAT] # desired display style and press the
joystick.
≥ The date and time function are driven by a built-in
lithium battery.
≥ Make sure to check the time before recording.
≥ If the time display becomes [--], the built-in lithium
battery has run down. Use the following steps to
charge the battery. When you turn on the power for
the first time after charging, a message asking you
to set the date and time will appear. Select [YES]
and set the date and time.
To recharge the built-in lithium battery
Connect the AC adaptor or attach the battery to the
unit, and the built-in lithium battery will be
recharged. Leave the unit as is for approx.
24 hours, and the battery will save the date and
time for approx. 6 months. (Even if the OFF/ON
switch is set to OFF, the battery is still being
recharged.)
[DATE] [D/T] [OFF]
Display
style
Y/M/D M/D/Y D/M/Y
Screen
display
2006.12.15 12.15.2006 15.12.2006
3:30 PM
12.15.2006
12.15.2006
D250&300(P_PC)eng.book 46 ページ ２００６年１月２０日 金曜日 午後２時３分