Panasonic HC-X900M Camcorder User Manual


 
13
VQT4C76
Inserting the battery
Open the LCD monitor and install the battery
by inserting it in the direction shown in the
figure.
Insert the battery until it clicks and locks.
Charging the battery
A DC input terminal
1 Connect the AC cable to the AC
adaptor, then the AC outlet.
2 Connect the AC adaptor to the DC input
terminal.
The status indicator will flash red at an
interval of 2 seconds (approximately 1
second on, 1 second off), indicating that
charging has begun. It will turn off when
the charging is completed.
Inserting/removing an SD card
Check that the access lamp has gone off.
1) Open the SD card cover and insert/
remove the SD card into/from the card
slot.
Face the label side B in the direction
shown in the illustration and press it
straight in as far as it will go.
Press the center of the SD card and then
pull it straight out.
2) Press the C part of the SD card cover
and close the SD card cover.
Securely close it until it clicks.
Quick Guide
Access lamp [ACCESS] A
When this unit is accessing the SD
card or built-in memory, the access
lamp lights up.
HC-X900M&X800P&PC&PU-VQT4C76_mst.book 13 ページ 2012年1月11日 水曜日 午後10時6分