Filter
Top Products
12
VQT1N74
Quick Guide
∫ Charging the battery
1 Connect the AC cable to the AC adaptor
and the AC outlet.
2 Insert the battery into the battery charger
by aligning the arrows.
∫ Inserting the battery
Open the LCD monitor and install
the battery by inserting it in the
direction shown in the figure.
A Insert the battery until it clicks and locks.
∫ How to turn on the power
Turn on the power by turning the
mode dial to , or while
pressing the lock release button A.
≥ Rotate the mode dial while at the same time
pressing in the lock release button if changing
from OFF to another mode.
≥ Status indicator B
≥ Align with the mark C.
≥ To turn off the power, set the mode dial to OFF.
∫ Inserting/removing an SD card
1 Set the mode dial to OFF.
2 Open the SD card cover while sliding the
SD CARD OPEN lever B.
3 Insert/remove the SD card.
≥ When inserting an SD card, face the terminal
side C in the direction shown in the illustration
and press it straight in as far as it will go.
≥ When removing the SD card, press the center
of the SD card and then pull it straight out.
4 Securely close the SD card cover.
≥ Securely close it until it clicks.
∫ Language selection
1) Press the MENU button, then select
[LANGUAGE] and press the cursor button.
2) Select [English] and press the cursor button.
Charging lamp
[CHARGE] A
Lights up:
Charging
Goes off:
Charging
completed
Card access lamp [ACCESS]
≥ When this unit is processing data, the
access lamp A lights up.
HDCHS9P-VQT1N74_ENG.book 12 ページ ２００７年１２月２５日 火曜日 午後８時４３分