Filter
Top Products
43
QR34642
Inserting and Removing Disc
Inserting Disc
1 Press down the DISC EJECT button once and
release it.
A few moments after the ACCESS/PC indicator
blinks, the cover of disc insertion block will open
slightly.
2 Gently open the cover by hand until it stops.
3 Insert the disc, in Round DVD Holder, into the
disc guide until it stops.
Note that the recording/playback surface of
disc must face the inside of DVD Palmcorder.
The orientation for inserting the disc into the
disc guide is also predetermined: Load the disc
correctly, referring to the figure below.
•
The disc exposed portion must face in the same
direction as the lens, as shown in figure.
• The recording/playback side must face the inside
(DVD Palmcorder).
4 Push the section marked “PUSH CLOSE” on
the cover of disc insertion block, to close the
cover.
5 Turn the DVD Palmcorder on ( VIDEO or
PHOTO).
When “DISC ACCESS” disappears, the DVD
Palmcorder is ready for recording.
●Identifying recording/playback
sides of disc:
Single sided disc:
The recording/playback side
is opposite to the printed label.
Double-sided disc:
The recording/playback side
of “SIDE A” is opposite to the
“SIDE A” marked side.
The recording/playback side
of “SIDE B” is the “SIDE A”
marked side.
Disc cover
DISC EJECT
button
PUSH CLOSE
portion
Disc
guide
Correct
orientation
Incorrect
orientation
Incorrect orientation
“SIDE A” mark
The opposite side is
the “SIDE A”
recording/playback
side.
VDR-M30PP_GB.book Page 43 Friday, March 14, 2003 8:53 PM