Filter
Top Products
Advanced
48
VQT0V40
Taking Pictures using
Burst Mode
1 Press the burst mode button to
switch the burst mode setting.
: High speed
;
: Low speed
;
:Unlimited
¢
1
;
No display: canceled
¢1 Depends on the memory size,
battery power, picture size and
quality (compression).
2 Take a picture.
• Hold down the shutter button fully to
activate the burst mode.
∫
Number of pictures recorded in burst mode
¢2 The burst speed is constant regardless
of the transfer speed of the card.
• The number of pictures indicated is when
the shutter speed is faster than 1/60 and
the flash is not activated.
• If you set the ISO sensitivity (P72) to
[ISO400] or [ISO800] and then take
pictures using burst mode, the number of
recordable pictures is less than indicated.
• In simple mode [ ], the settings become
as follows. [ ] appears on the left of the
screen. (P28)
– [ ENLARGE]:
/Max. 3 pictures
–[ 4qk6q/10k15cm]/[ E-MAIL]:
/Max. 5 pictures
• When the burst mode setting is set to
Unlimited
– You can take pictures until the capacity
of the built-in memory or the card is full.
– The burst speed will become slower
halfway. When the built-in memory is
used, the burst speed becomes a
maximum of 1 picture approximately
every 6 seconds. However, the exact
timing of this depends on the number of
recordable pictures and the card.
• The focus is fixed when the first picture is
taken.
• When the self-timer is used, the number
of recordable pictures in burst mode is
fixed to 3.
• Burst mode is not canceled when the
camera is switched off.
• When auto bracket and burst mode are
set simultaneously, auto bracket will be
performed.
• The exposure and the white balance vary
depending on the burst mode setting.
When burst mode is set to [ ], they are
fixed to the values set for the first picture.
When the burst speed is set to [ ] or
[ ], they are adjusted each time you
take a picture.
• When burst mode is set, the auto review
function is activated regardless of the auto
review setting. (The picture is not
enlarged.) You cannot set the auto review
function in the [SETUP] menu.
• When burst mode is activated,
[AUDIO REC.] cannot be used.
• When the flash is activated or
[STARRY SKY] in scene mode is
selected, you can take only 1 picture.
Burst speed
(pictures/
second)
Number of recordable
pictures (pictures)
3
¢2
max. 3 max. 5
2
¢2
approx. 2
Depends on the
remaining capacity of the
built-in memory/card.
SCN1
SCN
2
3
VQT0V40ENG.book 48 ページ ２００６年２月２７日 月曜日 午後１時１９分