7
Before Use
1
2
3
Before Using
Easy Cassette Eject/Insertion
• If the Palmcorder is connected to a power
source, the cassette can be inserted and
ejected without turning the Palmcorder
on.
• To remove the cassette...
Slide TAPE EJECT to open the Cassette
Compartment Cover and pull the cassette
tape straight out.
Before you begin
• Connect the Palmcorder to a power
source. (pp. 11, 12)
1LCD-OPEN
Cassette Compartment
Cover
2TAPE EJECT
4PUSH
CLOSE
1 Press LCD-OPEN to unlock the LCD
monitor, and swing it fully open.
2 Slide TAPE EJECT to open the
Cassette Compartment Cover.
3 Insert a cassette record tab up,
window side facing out.
4 Press PUSH CLOSE to close the
Cassette Compartment Cover.
1 Undo the two strap ends
from their buckles.
2 Thread the strap ends
through the Strap
Attachment Rings.
3 Reinsert the strap ends through their
buckles.
• Make sure the straps
are not twisted.
OR
1 Loosen the strap from the Buckle and
create a loop.
2 Pull the strap firmly through the
Buckle to shorten or lengthen the
strap.
1
Adjust the Length
Adjust the length of the Hand Strap to the
size of your hand as illustrated.
Attaching the Lens Cap Strap to the
Hand Strap:
Remove the Hand Strap from the front
clasp and thread the Strap through the loop
in the Lens Cap Strap.
Reattach the Hand Strap.
Lens Cap
Attaching the Shoulder Strap
2
1
3
Attaching the Lens Cap Strap:
Thread the Lens Cap Strap through the
Strap Attachment Ring as shown.
Hand Strap
Hand Strap
Note
• When inserting the cassette, make sure it
is facing the right direction and then push
it in completely.
DV53.p 5-8.p65 03/01/21, 16:257