Filter
Top Products
Re-Recording (Video/Audio Dubbing)
With only the Pause button on the editing unit, you
can control two Movies or a Movie and one table-
type VCR when you use their Synchro Edit jacks to
copy a tape. The Synchre Edit feature starts and
stops both the seurce and editing units together with
the press of one button.
=Set up and connect the units as illustrated. (Be
sure to connect the AC adaptor to an AC Outlet.)
If Both Units have Synchro Edit Jacks
-- Operation
On the Source Unit
I Insert the master tape into the unit.
Press Play to review the tape.
Press Pause/Still where you want to start the
playback of the master recording to copy it. The
source unit is now in Play/Pause.
On the Editing Unit
3 Insert the blank tape (or one you want to record
over) into the unit.
4 Press Play to review the tape.
Press Pause/Still where you want recording to
begin to make the copy of the master tape. The
editing unit is now in Play/Pause.
5 Press the Play and Rec buttons together.
The unit is now in Record/Pause.
Preparations:
=Turn ON both units.
=Set the AC Adaptor Input Signal Selector on the
Editing Movie to "LINE".
(Or set the editing VCR's Input Signal Selector to
"LINE".)
=Set the VCR/Camera Selector switch on the Movie
to the "VCR" position.
To Synchro Edit
The Synchro Edit feature simultaneously releases
the Pause mode on both units, so playback and
recording begin at the same time.
6 On the editing unit, press Pause to begin the re-
recording (both units begin operation).
7 Press Pause at the end of the recorded
sequence (the source unit goes into Play/Pause).
8 Press the Stop button on both units to stop
dubbing after completion.
Connection
Source: VCR or Movie Editing: Movie or VCR
Synchro Edit Cord (optional)
Synchro
Edit Jack
(This connection is for
unltswlth SynchroEdit
Jacks.)
Synchro
EdWRemote
Jack
TV Set
(Used for
monitodng)
VHF
Cable (supplied)
Video Out Audio Out
Adaptor
Connector
Input Signal Selector
Set to LINE
Video In
Audio In
3O
.3able(supplied)