Filter
Top Products
-10-
Power-in Connections
Notes:
• Use only a class-2 power supply suitable to the
voltage and current required by the camera. See
specifications.
• Use a UL listed cable (VW-1, style 1007) to pre-
vent fire or electric shock.
You can use the formula below to select the power
supply, and power cable. The supplied voltage to the
power-in terminals must be between 10.8V and 16V.
10.8V(minimum) ≤ VA – 2RLI ≤ 16V (maximum)
VA: Output voltage of power supply
R: Resistance (Ω/m) (Ω/ft), see table
L: Cable length (m) (ft)
I: Consumption current (A), see specifications
CONNECTIONS
Copper wire #24 #22 #20 #18
size (AWG) (0.22 mm
2
) (0.33 mm
2
) (0.52 mm
2
) (0.83 mm
2
)
Resistance 0.078 0.050 0.030 0.018
Ω/m
Resistance 0.026 0.017 0.010 0.006
Ω/ft
Resistance of copper wire [at 20°C (68°F)]
1. Connect the power cable to the terminals while
identifying the polarity.
2. Fasten the screws.
Video Cable Connections
The maximum extensible coaxial cable length between
the camera and the monitor is shown in the table.
Type of RG-59/U RG-6/U RG-11/U RG-15/U
coaxial cable (3C-2V) (5C-2V) (7C-2V) (10C-2V)
Recommended (m) 250 500 600 800
maximum
cable length (ft) 825 1 650 1 980 2 640
DC 12V
IN
12 V DC
(10.8 V - 16 V)
Control Terminal Connections
Connect relevant devices as shown in the figure.
ALARM IN
ALARM OUT
AUX OUT
DAY/NIGHT IN
GND
Sensor
Recording device e.g. VCR
Optical sensor
ON: B/W,
OFF: Color
Aux devices e.g. lamp
ALARM IN
ALARM OUT
DAY/NIGHT IN
AUX OUT
Notes:
• See specifications for each terminal.
• Use a relay when the connected device exceeds
the ratings in voltage or current.
• The optical sensor validates the Day/Night function
if B/W is set to EXT in the setup menu.
Network Connections
Network Connection Types
• Use a router or switching hub when multiple cam-
eras are connected.
• Use a router handling PPPoE (PPP over Ethernet)
when running PPPoE to connect with the Internet,
because the camera is incapable of it.
• Use network cables complying with category5.
•Direct Connection to PC (Type 1)
ALARM IN
ALARM OUT
AUX OUT
DAY/NIGHT IN
GND
AB
VIDEO OUT
RCV
LINK
10BASE-T/
100BASE-TX
POWER
Network Cable (Cross type)
PC
DC 12V
IN