Filter
Top Products
t
i
yo
u
q w e
r
WV
–
NP472
ALARM IN
ALARM OUT
AUX OUT
DAY/NIGHT IN
GND
AB
VIDEO OUT
RCV
LINK
10BASE-T/
100BASE-TX
POWER
DC 12V
IN
!3
!4
!2!1
!0
-7-
MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS
Slide the panel to the left until it locks.
q Auto Iris Lens Connector
Connects the auto iris lens with a 4-pin male con-
nector supplied as a standard accessory (Part No.
YFE4191J100).
w Flange-back Adjusting Ring & Screw
Adjusts the back focal length and picture focus.
e Lens (Option)
r Camera Mounting Adapter
Mounts the camera onto a mounting bracket.
t Down Button (K)
Moves the cursor downward and selects items in
the CAM SET UP menu.
y Left Button (L)
Moves the cursor leftward, selects the mode and
adjusts some levels.
u Up Button (J)
Moves the cursor upward and selects items in the
CAM SET UP menu.
i Right Button (M)
Moves the cursor rightward, selects the mode and
adjusts some levels.
o Set Button (I)
Activates an item selected in the CAM SET UP
menu.
!0 Network Port with Indicators (10BASE-
T/100BASE-TX/RCV/LINK)
Connects to a PC or a network via a hub with a
10BASE-T/100BASE-TX cable attached RJ-45 con-
nector. Indicators will light up while receiving data
(RCV) or establishing communications (LINK).
!1 Control Terminals
Connects respective devices.
ALARM IN: Alarm sensor, ALARM OUT: Recording
device/alarm indicator, AUX OUT: External device,
DAY/NIGHT IN: Optical sensor, GND: Signal
ground
!2 Reset Button (A, B)
The button A, along with the J and K buttons,
resets the network setup parameters when you
hold down these buttons for 6 seconds in the
power-on state.
The button B resets the HTML files and alarm mail
setup in the same manner as the button A.
Note: Never press both the reset buttons A and B
at a time.
!3 Video Output Connector (VIDEO OUT)
Supplies analog video signal (composite) to the
connected device.
!4 Power In Terminal and Power Indicator
(DC 12V IN, POWER)
Connects to a DC power supply using proper
cables. The power indicator lights up when power
is supplied.