Filter
Top Products
-22-
To reset to the factory settings (CAMERA RESET)
1. Move the cursor to CAMERA RESET. PUSH SW is
highlighted.
2. While holding down L and M, hold down I
for 2 seconds or more. The camera is reset to the
factory settings.
NETWORK SETUP
Set up network parameters when connecting the
10/100BASE jack with a network.
Notes:
• Access the setup menu from the PC to use the
DHCP or DNS server, because these settings are
not included in this window.
• Ask your system administrator or ISP (Internet
Service Provider) about available IP address, sub-
net mask, and gateway, prior to setup.
• The assigned address should be a global type
when connecting via the Internet. Ask your ISP
whether it is.
1. Move the cursor to NETWORK SETUP in the SETUP
menu window and press I. The NETWORK
SETUP menu opens.
The factory default settings are as follows.
IP ADDRESS: 192.168.0.10
NETMASK: 255.255.255.0
GATE WAY: 192.168.0.1
HTTP Port Number: 80
2. Move the cursor to the line you wish to edit, and
press I.
Parameters become editable.
3. Select a digit using J or K.
4. Select a number in the digit using L or M.
5. Repeat steps 2, 3 and 4 above appropriately until
all parameters are set.
6. Move the cursor to END and press I to close the
setup menu and store new settings, or select RET
to go back to the SETUP menu.
Note: The port number assigned to the camera is
exclusive, and any other usage is not allowed.
** NETWORK SET UP **
IP ADDRESS
192.168. 0. 10
NETMASK
255.255.255. 0
GATEWAY
192.168. 0. 1
HTTP PORT NO. 80
RET END