Filter
Top Products
44
Configure the settings relating to the camera action at an alarm occurrence
Click the [Alarm] tab on the "Alarm setup" page. (☞ page 15)
■ Camera motion on alarm
The settings relating to the camera action at an alarm occurrence can be configured in this section. Refer to pages
43, 46 and 47 for further information about the settings relating to the alarm, the alarm image and the alarm output
terminal.
[Terminal alarm 1]
Select an action to be taken when a terminal alarm 1 is
detected from the following.
OFF: Does not take any action even when a terminal
alarm 1 is detected.
1-64: When the registered preset position is selected,
the camera will move to the selected preset position
when a terminal alarm 1 is detected.
Auto track: When a terminal alarm 1 is detected, the
camera will move to the home position and start the
auto tracking.
Alarm permission: Receives a terminal alarm 2 and 3
while detecting a terminal alarm 1.
VMD permission: Permits to detect video motion (VMD
function) while detecting a terminal alarm 1.
Access permission: Permits access from all the users
registered on the "User" page (☞ page 54) while
detecting a terminal alarm1. Permits access from
users whose access level is "1" while no detecting a
terminal alarm 1.
Default: OFF
Important:
When "Access permission" is selected for "Terminal
alarm 1", select "ON" for "User authentication" on
the [Authentication] tab (☞ page 54).
[Terminal alarm 2]
Select an action to be taken when a terminal alarm 2 is
detected from the following.
OFF: Does not take any action even when a terminal
alarm 2 is detected.
1-64: When the registered preset position is selected,
the camera will move to the selected preset position
when a terminal alarm 2 is detected.
Auto track: When a terminal alarm 2 is detected, the
camera will move to the home position and start the
auto tracking.
Default: OFF
[Terminal alarm 3]
Select an action to be taken when a terminal alarm 3 is
detected from the following.
OFF: Does not take any action even when a terminal
alarm 3 is detected.
1-64: When the registered preset position is selected,
the camera will move to the selected preset position
when a terminal alarm 3 is detected.
Auto track: When a terminal alarm 3 is detected, the
camera will move to the home position and start the
auto tracking.
Default: OFF
"AUX" is the terminal that can be switched between
"OPEN" and CLOSE" from the "Live" page. It is useful
when controlling the connected external device. For
example, when it is necessary to control lighting at the
camera location, connect a lighting control device to the
terminal (AUX OUT) of the camera to remotely control
lighting at the camera location.
[VMD alarm]
Select an action to be taken when a VMD alarm is
detected from the following.
OFF: Does not take any action even when a VMD alarm
is detected.
1-64: When the registered preset position is selected,
the camera will move to the selected preset position
when a VMD alarm is detected.