Filter
Top Products
C2910M-C (4/06) 15
UNSHIELDED TWISTED PAIR (UTP) LEADS
The CCC5100H Series camera supports composite video over unshielded twisted pair (UTP) cabling. The camera UTP video output signal is
1 Vp-p differential into a 100-ohm load.
At a minimum, UTP requires Cat5, 100-ohm twisted pair cable. You can install either a passive or an active UTP receiver at the head-end. Table F
lists the maximum UTP wiring distances. It also lists the restrictions when using either type of UTP receiver.
NOTE:
The CCC5100H Series camera supports video to both active and passive UTP receivers. However, Coaxitron and Pelco V-Sync are only
supported when using a passive UTP receiver. Refer to
Using Coax Video
for information about Coaxitron and Pelco V-Sync.
Table F.
UTP Wiring Distances
Connect the UTP video wires to the multifunction connector (refer to Table G).
Table G.
UTP Video Connections
POWER LEADS
Connect the power wires to the multifunction connector (refer to Table H).
Table H.
Low Voltage Power Connections
USING THE SERVICE CONNECTOR
The CCC5100H Series camera rear panel includes a service connector that outputs camera video and gives access to the setup menus. Use it to
configure the camera quickly and easily at the installation site.
Pelco offers two camera setup tools that plug into the service connector on the CCC5100H Series camera.
CST150:
This tool has top, center, and bottom buttons that operate like the three rear panel camera buttons. It also has a microdisplay to show
video directly from the camera.
CST100:
This tool has top, center, and bottom buttons that operate like the three rear panel camera buttons. It also has a video output connector
to show video directly from the camera on a separate monitor.
You can use either tool to configure the CCC5100H Series camera with only one hand.
Receiver Distance
Active
(Video Only)
0-3,000 ft
(0-914.4 m)
Passive
(Video, Coaxitron,
Pelco V-Sync)
0-750 ft
(0-228.6 m)
Pin Lead
5 UTP- Video
6 UTP+ Video
WARNING:
Do not connect high voltage power through the multifunction connector or you may damage the camera.
Pin 12-36 VDC
±10%
24-28 VAC
±10%
8 GND LO
9 Power HI
WARNING:
Apply power to either the power connector or the multifunction connector. The camera cannot accept power at both
connectors at the same time.