Filter
Top Products
24 C2910M-C (4/06)
CAMERA DISPLAY MENU
Use the CAMERA DISPLAY menu to set camera identification information and to configure gamma,
saturation, automatic gain control (AGC), and sharpness.
Camera Name
Enter the display name for this camera, one character at a time, up to 12 characters. The default is
CCC5100H.
When you select this option, a cursor appears under the first character in the camera name.
1. Press and hold the top or bottom button to scroll through the characters.
2. Press the center button to select the displayed character. The cursor moves to the next character position.
3. Repeat steps 1 and 2 for each character. When you press the center button at the last character position, the cursor moves to the first
character position.
4. Press and hold the center button to exit the CAMERA NAME option.
RX Address
The CCC5100H Series camera can be accessed remotely from selected Pelco controllers. Select an RX (receiver) ADDRESS for this camera, from
1 to 255. The default is 1.
Use a short center press to set the RX ADDRESS. The display blinks and the cursor exits to the menu.
Be sure to assign an RX address before accessing the camera remotely.
Save RX Address
Select this option to save the RX ADDRESS into nonvolatile camera memory. It will not be erased, either by cycling power or by restoring factory
settings.
The menu blinks several times.
DISPLAY PROPERTIES
Use this menu to configure the following settings:
Name Pos.
Select the position in the image to display the camera name: UPPER LEFT, UPPER RIGHT, LOWER LEFT, or
LOWER RIGHT. Select OFF to not display the camera name. The default is OFF.
Color Bars
Select ON to display color bars. Use this feature to adjust the camera and/or monitor settings. The default
is OFF.
When you exit this feature, the camera automatically disables the color bars if they are displayed.
Horiz Image Flip
Select ON to flip or mirror the image horizontally. The default is OFF.
Black/White Mode
Select ON to operate the camera in black and white mode. The default is OFF.
GAMMA/SATURATION
Use this menu to configure the following settings:
Gamma Correction
Gamma correction adjusts the video signal to compensate for the nonlinear response of the monitor display.
Select OFF to disable gamma correction.
Select AUTO to use 45% (0.45) for NTSC or 36% (0.36) for PAL.
Select MANUAL to use a manual gamma correction setting. Be sure to adjust the MANUAL GAMMA setting.
The default depends on the selected profile (refer to Table K).
CAMERA NAME CCC5100H
RX ADDRESS 1
SAVE RX ADDRESS
<DISPLAY PROPERTIES>
<GAMMA/SATURATION>
<GAIN CONTROL>
<SHARPNESS>
BACK
EXIT
CAMERA DISPLAY
NAME POS. OFF
COLOR BARS OFF
HORIZ IMAGE FLIP OFF
BLACK/WHITE MODE OFF
BACK
EXIT
DISPLAY PROPERTIES
GAMMA/SATURATION
GAMMA CORRECTION
MANUAL GAMMA
25 100
SATURATION
-8 8
BACK
EXIT
|-----+-----|
|-----+-----|
AUTO