Filter
Top Products
C3463M-B (2/11) 21
Display Setup
*This setting applies to Pressurized Spectra IV dome systems only.
†
Azimuth is the pan angle from zero to 359 degrees.
‡
Elevation is the tilt position from zero (horizon) to –90 degrees.
EXIT
SPECTRA IV
LANGUAGE
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
BACK
EXIT
PRESET LABEL
ZONE LABEL
ZOOM
AZIMUTH/ELEVATION
DIRECTION
ALARM MESSAGE
DATE/TIME
EVENT LABEL
<LABEL POSITIONS>
RESTORE FACTORY DEFAULTS
DISPLAY SETUP
Display setup allows you to configure how labels are displayed on the monitor. The following labels are available:
PRESET LABEL: Identifies preset.
ZONE LABEL: Identifies zone.
ZOOM: Identifies the amount of magnification.
AZIMUTH
†
/ELEVATION
‡
: Amount of pan from zero degrees vertical and the amount of tilt from zero degrees horizontal.
DIRECTION: Displays compass direction.
ALARM MESSAGE: Displays activated alarm.
DATE/TIME: Displays current date and time.
EVENT LABEL: Displays activated event.
A preset label is displayed when a preset is called. A zone labe
l is displayed when the system moves into a zone. The zoom ratio label is
displayed when zoom is activated. Azimuth/elevation and direction labels are displayed when pan/tilt is activated. An alarm message appears on
the monitor when an alarm occurs. An event label appears on the monitor when an event occurs.
The following settings are available for each label except date and time:
OFF: Label is not displayed when activated.
CONSTANT: The label is continually displayed when activated.
2 SECONDS: The label is displayed for 2 seconds after activation.
5 SECONDS: The label is displayed for 5 seconds after activation.
10 SECONDS: The label is displayed for 10 seconds after activation.
The settings for date and time are ON or OFF.