Filter
Top Products
C3463M-B (2/11) 29
LOW LIGHT SHARPNESS
(Applies to 27X and 35X models only.)
Low light sharpness allows you to control the video sharpness in low-light scenes. The available settings are 20, 10, DEFAULT, –1
0, and –20.
Increasing the value increases sharpness in low-light scenes, but also increases video noise. Decreasing the value decreases video noise in
low-light scenes, but it also decreases image sharpness.
NOTE: C
hanging the low light sharpness causes the camera to reset, which resets all camera settings to their factory defaults.
MINIMUM FOCUS DISTANCE
(Applies to 27X and 35X models only.)
Minimum focus distance improves focus capability in low-light scenes, depending on the typical distance between the camera and objec
ts in the
scene. There are two settings:
30 CM (default): Impr
oves focus for scenes in which the camera is typically focusing on objects at close range (less than 3 meters).
3 M: Improves
focus for scenes in which the camera is typically focusing on objects at a distance of 3 meters or more.
EXIT
SPECTRA IV
LANGUAGE
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
<CAMERA>
<MOTION>
<AUTO TRACKING>
<POWER UP>
<LINE SYNC>
<PRESETS>
<PATTERNS>
<ZONES>
<WINDOW BLANKING>
<ALARMS>
<AUX>
<TITLE TEXT>
<ALERT>*
<CLEAR>
<PASSWORD>
<CLOCK>
<EVENT>
BACK
EXIT
DOME SETTINGS
AUTO FLIP
PROPORTIONAL PAN
PARK TIME (MINUTES)
PARK ACTION
SCAN SPEED (DEG/S)
PRESET FREEZE FRAME
LIMIT STOPS
<SET MANUAL STOPS>
<CLEAR MANUAL STOPS>
<SET SCAN STOPS>
<CLEAR SCAN STOPS>
<SET AZIMUTH ZERO>
<CLEAR AZIMUTH ZERO>
BACK
EXIT
REFERENCE INFORMATION
MANUAL LIMITS SET
SCAN LIMITS SET
MOTION
MOTION SETTINGS
*This setting applies to Pressurized Spectra IV dome systems only.
AUTO FLIP
When the camera tilts downward and goes just beyond the vertical position, the dome rotates 180 degrees. When the dome rotates (flips), the
camera starts moving upward as long as you continue to hold the joystick in the down position. Once you let go of the joystick after the dome
rotates, joystick control returns to normal operation. The auto-flip feature is useful for following a person who passes directly beneath the dome.
There are two auto flip modes:
ON (default): Auto flip mode is
enabled.
OFF: Auto flip mode is disabled.
PROPORTIONAL PAN
Proportional pan automatically reduces or increases the pan and tilt speeds in proportion to the amount of zoom. At telephoto zoom settings, the
pan and tilt speeds will be slower for a given amount of joystick deflection than at wide zoom settings. This keeps the image from moving too
fast on the monitor when there is a large amount of zoom.
There are three proportional pan modes:
ON (default): Enables the proportional pan mode.
OFF: Disables proportional pan mode. The pan speed will not depend on the amount of zoom.
2X: Increases the speed of the proportional pan mode to twice that used when proportional pan is set to ON.