Filter
Top Products
EXIT
SPECTRA IV
LANGUAGE
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
BACK
EXIT
PRESET LABEL
ZONE LABEL
ZOOM
AZIMUTH/ELEVATION
DIRECTION
ALARM MESSAGE
DATE/TIME
EVENT LABEL
<LABEL POSITIONS>
RESTORE FACTORY DEFAULTS
DISPLAY SETUP
[ZONE LABEL-------]
[PRESET LABEL-------]
[ALARM --------]
[ALERT MESSAGE-------]*
<TITLE TEXT>
SAVE AND EXIT
CANCEL
HELP
NE
XX°/-XX°
MM/DD/YYYY
[EVENT--]
XXX.X*
12:00:00 AM
LABEL POSITION
22 C3463M-B (2/11)
LABEL POSITIONS
*This setting applies to Pressurized Spectra IV dome systems only.
†
Azimuth is the pan angle from zero to 359 degrees.
‡
Elevation is the tilt position from zero (horizon) to –90 degrees.
§
The alert message is the warning displayed on the monitor if pressure, temperature, or dew point inside the dome reach unacceptable levels.
Labels can be placed anywhere on the monitor. This feature allows you to customize the appearance of your monitor screen.
The following labels are not set at fixed positions:
ZONE LABEL
PRESET LABEL
ALARM
ZOOM RATIO - XXX.X*
AZIMUTH
†
/ELEVATION
‡
- XX°/-XX°
DIRECTION - NE
ALERT MESSAGE*
§
TITLE TEXT
EVENT LABEL
DATE/TIME
To set a label position:
1. Use the joystick to position the cursor beside a label.
2. Press Iris Open.
3. Use the joystick to move the label
up, down, left, or right.
4. Press Iris Open.
5. Repeat steps 1 to 4 to position other labels.
6. Position the cursor next to Save and Exit. Press Iris Open to save settings and exit the menu.