Filter
Top Products
Pelco Manual C540M (6/98) 11
3.2.2 To Leave Setup Mode
1. Select and return DIP switch 2 to the OFF position.
3.2.3 Creating a Setup PIN
The factory settings for the CM9760-KBD include the default password 1234. An
alternative password can be defined as follows:
1. While in
setup
mode, use and/or to locate
Advance Setup 4
.
2. Select , type a four-digit PIN, and select once again.
3. Select Confirm, retype the PIN, and select once again.
3.2.4 Creating a Define PIN
The factory settings for the CM9760-KBD include the default password, 1234. An
alternative password can be defined as follows:
1. In
setup
mode, use and/or to locate
Advance Setup 4.
2. Select
Define PIN
using and/or .
3. Select
, type a four-digit PIN, and select once again.
4. Select Confirm, retype the PIN, and select once again.
3.2.5 Calibrating the Joystick
To make the joystick operational, proceed as follows:
1. In
setup
mode, select .
2. With the joystick in the central default position, select
.
3. Move the joystick fully left, and select
.
4. Move the joystick fully right, and select
.
5. Move the joystick fully down, and select
.
6. Move the joystick fully up, and select .
7. Save the joystick configuration by selecting .
8. Select
.
3.2.6 Adjusting the Display Brightness
While in
setup
mode, the brightness of the display can be adjusted. This is done by
selecting
, after which the display may be brightened or darkened using
or . When satisfied with the brightness setting, press followed by .
NOTE:
A PIN is required to enter
SETUP mode.
NOTE:
A PIN is required to use the
features that are accessible via the
DEFINE menu.
> SETUP PIN ****
CONFIRM ****
DEFINE PIN ****
CONFIRM ****
ADVANCE SETUP 4
JOYSTICK SETUP
XXX
XXX (XXX, XXX) XXX
XXX
NOTE:
The display brightness can
also be adjusted by selecting
from
the define sub-menu. The define sub-
menu is produced by selecting
.
LCD BRIGHTNESS SETUP