Pentax Optio W20 Digital Camera User Manual


 
77
4
Taking Pictures
R q < B i \ E
4 Q D N J R
In this mode, pictures are taken continuously for as long as the shutter
release button is pressed.
1 Press the four-way controller (2) in A mode.
2
Use the four-way controller (
453
)
to select
1
(Continuous Shooting)
or
c
(HS Cont. Shooting) and press
the
4
button.
The camera is ready to take a series of pictures.
3 Press the shutter release button
halfway.
The focus frame on the LCD monitor turns green if the subject is in focus.
4 Press the shutter release button fully.
Pictures are taken continuously for as long as you keep the shutter
release button pressed.
Taking a Series of Pictures (Continuous Shooting
Mode/High Speed Continuous Shooting Mode)
1
Continuous
Shooting
Each time a picture is taken, the image is saved in the memory
before the next image is taken. The higher the image quality,
the longer the interval between shots.
c
HS Cont.
Shooting
Pictures are taken continuously at a speed of 3 frames per
second until the buffer memory is full.
The flash will not discharge in Continuous Shooting and High
Speed Continuous Shooting mode.
The continuous shooting function is not available in 5, A, C,
O, Y, I, Q, C, X, >, y or 9 mode.
You can continue shooting until the memory capacity of the SD
Memory Card or built-in memory is full.
The interval of continuous shooting will vary according to the
Recorded Pixels and Quality Level settings.
The number of recorded pixels is fixed at h in high speed
continuous shooting mode. When shooting mode is set to R, the
number of recorded pixels is set to V (1280×960).
The focus, exposure and white balance are locked with the first image.
3, 4
1, 2
2
Drive Mode
Drive Mode
Continuous Shooting
Continuous Shooting
Drive Mode
Continuous Shooting
OK
OK
OK
OK
HS