Filter
Top Products
ENGLISH
Menu
E-111
Item
Display
mode
Description of settings
REC COUNTER (Camera) Selects counter operation during recording.
TOTAL:
Continues counting until card is reset with the COUNTER RESET
button.
CLIP:
Resets the counter at start of recording and counts the time of each
recording session.
CARD FUNCTIONS screen
Item
Display
mode
Description of settings
SCENE FILE (Camera) Reads/writes scene les from/to the SD memory card.
FILE SELECT: You can specify the le numbers of the les to be
read/written.
READ: You can read the setting values of the scene les (1 to 4) from
the SD memory card by specifying the le number.
WRITE: Saves the current setting values of the scene les (1 to 4) to
the SD memory card.
TITLE RELOAD: Updates the title list.
USER FILE (Camera) Reads/writes user les (excluding scene les) from/to the SD memory
card.
FILE SELECT: You can specify the le numbers of the les to be
read/written.
READ: You can read the setting values of the user les (1 to 4) from
the SD memory card by specifying the le number.
WRITE: Saves the current setting values of the user les (1 to 4) to the
SD memory card.
TITLE RELOAD: Updates the title list.
SD CARD FORMAT (Camera) Formats the SD memory cards.
OTHER FUNCTIONS screen
Item
Display
mode
Description of settings
USER FILE (Camera)
(MCR)
LOAD:
Loads the settings in a previously stored user le.
SAVE:
Saves the updated user le settings.
INITIAL:
Returns the user settings in the user le to the factory settings.
After a LOAD or INITIAL operation, turn the POWER switch off and
then back on again to make the new settings available.
An INITIAL operation does not change the TIME ZONE settings
(Page 113).
•
REMOTE (Camera)
(MCR)
Sets the operations of the supplied remote control unit. (Remote control
setup. (Page 18))
OFF:
Operations are not accepted from any remote control.
1:
Accepts commands from the remote control set for “operation mode 1”
2:
Accepts commands from the remote control set for “operation mode 2”.
___indicates the factory setting.
DISPLAY SETUP screen (continued)