Filter
Top Products
E-117
ENGLISH
Reference
Playback
Cannot play even when I
press the play button.
Make sure the MCR lamp is on (press the mode button).
No kind of playback operation can be performed unless this lamp
is on.
• P64
Mosaic-like noise appears
when I cue or review a
tape.
This noise is inherent to digital video technology.
This is normal.
• ——
Images do not appear on
the television even though
I have connected the
camera-recorder properly.
Make sure the input selector on your television is set to video
input.
Read the television’s instructions carefully and select the correct
video input connector for the camera-recorder.
• ——
Cannot hear any sound
from the camera-
recorder’s speaker.
You may have turned down the camera-recorder’s volume control
too far.
Adjust the volume level using the PAGE/AUDIO MON/
VAR button+.
• P76
Cannot perform hot swap
playback.
This unit does not support hot swap playback.
To replace one card with another during dubbing, stop the
dubbing rst, and upon completing the replacement, resume it.
• P87
Other
Cannot read the data on
the SD memory card.
Make sure the SD memory card is formatted correctly.
If it is not, format the card in the unit.
• P29
The remote control does
not work.
The battery in the remote control may have run out.
If the remote control fails to work even if it is operated close to the
remote control sensor of the camera-recorder, it means that the
battery has run out. Replace it with new one.
• P18
Make sure the remote control setting is the same for the remote
control unit and the camera-recorder.
If the REMOTE setting is different on the remote control and the
camera-recorder, the remote control will not work.
• P18
There is a rattling sound
when the camera-recorder
is tilted back and forth.
There are some parts of the camera that make a rattling sound
in the MCR mode or when the POWER switch is OFF. This is
normal.
• ——
A clicking sound is heard
when the power is turned
on or when the MCR
mode is switched to the
CAM mode.
This initialization operation is performed when the camera starts
up.
It occurs due to the construction of the camera and is not
indicative of any trouble.
• ——