Filter
Top Products
English_21
●
SETUP
6615
2.
Select a desired mode using the Function Setup switch depending on the camera
purpose.
UseR blC
: Enables a user to directly
select a desired area from a
picture, and to view the area
more clearly.
LEVEL : Adjust level of the BLC function.
TOP/BOTTOM/LEFT/RIGHT :
Adjust the area to be enhanced.
-
-
BLC SETUP
▶ 1.LEVEL
MIDDLE
2.TOP
IIIII
IIIIIIIIIIIIIIII
9
3.BOTTOM
IIIIIIIIIIIIIIIIII
III
23
IIIIII
IIIIIIIIIIIIIII
40
5. RIGHT
IIIII
81
6. RETURN
IIIIIIIIIIII IIII
HlC (High light Compensation) :
This function masks the strong light to
minimize white out due to over exposure and
preserve much of the on-screen details when
the camera aims a strong light source.
LEVEL : Adjusts the brightness level of a
monitoring area.
LIMIT :
-
-
-
MASK COLOR
:
HLC SETUP
▶ 1. LEVEL
MIDDLE
2. LIMIT
NIGHT ONLY
3. MASK COLOR BLACK
4. RETURN
Enable to change the operating condition.
Off
: Not being used
4.LEFT
Change the color of the masking area. (Black, Red, Blue, Gray,
Magenta)
SSNR3
IIIIIIIIIII
12
IIIIIIII IIIIII
▶ LEVEL
RETURN
This function reduces the background noise in a low luminance environment.
1.
When the SETUP menu screen is displayed, select 'SSNR3' by using the Function
Setup switch so that the arrow indicates 'SSNR3'.
2.
Off : Deactivates SSNR3. Noise is not reduced.
ON : Activates SSNR3 so that noise is reduced.
3. Set the SSNR3 mode to 'ON' and press the Function Setup switch.
4. Then you can adjust the noise reduction level.
You cannot set the SSNR3 to 'ON' or 'OFF' when the AGC mode of the EXPOSURE
menu is 'OFF'.
When adjusting the noise reduction level of the SSNR3 mode, remember that the higher
the level set, the more the noise level will be reduced but that after image may also occur.
Select a desired mode using the Function Setup
switch.
1.
2.