Filter
Top Products
setup screen
62_ setup screen
QoS
You can specify the priority to secure a stable transfer rate for a specific IP.
1. From the Setup menu, select the
<Network (
)> tab.
2. Click <QoS>.
3. Provide the IP address.
The default prefix is 32. For DSCP, the
default is set to 63.
4. Select an IP address to which you will
apply QoS.
Only the selected IPs can be prioritized.
5. When done, click [Apply (
)].
SNMP
With the SNMP protocols, you can allow the system or network admin to monitor the
network devices on a remote site, and configure the environment settings.
1. From the Setup menu, select the
<Network ( )> tab.
2. Click <SNMP>.
3. Specify the <SNMP>.
• Enable SNMP v1 : SNMP version 1
will be active.
• Enable SNMP v2c : SNMP version 2
will be active.
- Read Community :
Provide the
name of the read community where you can access to the SNMP information.
The default name is “pubic”.
- Write Community :
Provide the name of the write community where you can
access to the SNMP information. The default name is “write”.