Filter
Top Products
故障排除
故障排除
在聯絡 Samsung 授權的維修中心之前，請執行下列簡單檢查。
這將可節省不必要的撥電時間和費用。
警告指示器和訊息
整體
訊息 圖示 表示… 措施
Low Battery
電池組幾乎完
全放電。
更換充電電池或連接交流電源適配
器。（如果在顯示「Low Battery」時
連接交流電源適配器，會關閉電源，
同時會開始充電。）
Cover is
opened
打開護蓋。 合上護蓋。
光碟
訊息 圖示 表示… 措施
Insert Disc
DVD 攝錄放影
機中沒有光碟。
插入光碟。
Disc Full
沒有足夠的光
碟空間。
更換新的光碟。刪除已錄製的影像。
Finalised
Disc
光碟已終結。
要在 DVD-RW/+RW 光碟上錄製，可
對其取消終結。
Not
Supported
Disc
光碟無法在
DVD 攝錄放影
機中識別。在
其他公司製造
的攝錄放影機
中終結光碟。
支援的光碟有：DVD-R、DVD+R DL、
DVD-RW 和 DVD+RW。使用新光碟。
Disc Error
檔案系統與光
碟不相符。
在電腦中格式
化光碟。
重新格式化 -RW/+RW 光碟。
不可刮擦光碟表面。
Write Error
在寫入資料時，
您的光碟或記
憶卡出現了一
些問題。
在將影片錄製
到光碟時，光
碟會振動。
要恢復光碟或記憶卡中先前的資料，
請關閉電源，然後重新開啟電源。
在恢復資料後，系統將被切換到
STBY
模式。如果無法恢復資料，
會出現「
Disc Error
」或「
Card
Error
」。
104_ English
臺灣
_104
TROUBLESHOOTING
Before contacting a Samsung authorized service centre, perform the
following simple checks.
They may save you the time and expense of an unnecessary call.
Warning indicators and messages
Overall
Message Icon Informs that... Action
Low Battery
The battery
pack is almost
discharged.
Replace with a charged battery or connect
the AC power adaptor. (If the AC power
adaptor is connected when “Low Battery” is
displayed, the power is turned off and the
charging starts.)
Cover is
opened
Cover is opened.
Close the cover.
Discs
Message Icon Informs that... Action
Insert Disc
There is no
disc in DVD
camcorder.
Insert a disc.
Disc Full
There is not
enough disc
space.
Change to a new disc. Erase recorded
image.
Finalised
Disc
The disc is
finalised.
To record on a DVD-RW/+RW disc,
unfinalise it.
Not
Supported
Disc
The disc is not
recognized in the
DVD camcorder.
The disc is
finalised in the
camcorders
manufactured by
other companies.
The supported discs are DVD-R, DVD+R
DL, DVD-RW and DVD+RW. Use a new
disc.
Disc Error
File system does
not match to the
disc.
Disc is formatted
in the PC.
Reformat the disc for –RW/+RW.
There should be no scratches on the
surface of the disc.
Write Error
Your disc or
memory card has
some problems
in writing data.
Disc is shocked
while movies is
being recorded
onto the disc.
To recover previous data in your disc or
memory card, turn the power off and on.
After recovering data, the system will
be switched to STBY mode. If it fails to
recover data, “Disc Error” or “Card
Error” appear.
troubleshooting
Eng+Tai_VP.indb 104 2008-03-07 ¿ÀÈÄ 6:27:57