Filter
Top Products
HARD DISK STANDBY MODE
When shooting or recording ends, switch the hard disk to standby mode.
Setting to standby mode
1 Press the MENU button.
The MAIN MENU screen will be displayed.
2 While pressing the MENU button, press
the SET button.
After the current image has been recorded on
the hard disk, the disk will change to standby
mode. During recording, the message “DISK
CLOSING” will be displayed for approximately
2 seconds.
Furthermore, the warning indicator and
caution indicator will both switch off while the
hard disk is in standby mode.
Note:
•
The caution indicator will flash until the hard
disk changes to standby mode. None of the
setting details will change when the hard disk is
in standby mode.
•
This operation (DISK CLOSING) cannot be
carried out using the camera control unit (sold
separately).
Canceling standby mode
If you press the MENU button, the MAIN MENU
screen will be displayed.
To start pre-alarm recording, select RECORD START
and then press the SET button. Furthermore, if the
MAIN MENU screen remains displayed for 30
seconds, the camera will change automatically to
pre-alarm recording.
Press the MENU button.
Pre-alarm recording will then start.
Note: The warning indicator and caution indicator
will both flash while the hard disk contents
are being checked. When pre-alarm
recording starts, the caution indicator will
light.
(MAIN MENU)
RECORD START
PLAYBACK
SETTINGS
CONDITION
MENU
DISK CLOSING
MENU SET
MENU
PRE1-ALARM REC PRE1-ALARM REC
REMAIN SHOTS: 6834 REMAIN SHOTS: 6834
PRE1-ALARM REC
REMAIN SHOTS: 6834
L42A4/US (DSR-C100) GB 2001, 4, 16
18 English