Sanyo DSR-C100 Camcorder User Manual


 
Screen displays
1 Display during recording
During recording, the screen display will switch off
after 30 seconds have passed. You can make the
screen display re-appear by pressing the SET or
CURSOR button.
The screen display can be set to switch off immediately
from the start of recording. To do this, set “CAUTION
LED” on the SYSTEM SET screen to OFF. To re-display
the screen, set it back to ON. (See page 23)
2 Number of suspicion recording images
Pre-alarm recording
1 Press the MENU button.
The MAIN MENU screen will be displayed.
If the MAIN MENU screen remains displayed for about
30 seconds, pre-alarm recording will then start
automatically.
2 Use the CURSOR (j or l) button to select
“RECORD START” and then press the SET button.
PRE1-ALARM REC” will be displayed and
pre-alarm (PRE1) recording will start.
The warning indicator and caution
indicator both light during pre-alarm
recording.
Note: Pre-alarm recording will continue with the images being recorded in the pre-alarm (PRE1) area of the
hard disk until the hold-up switch or suspicion switch at the back of the camera is pressed.
3 Press the MENU button to stop recording.
The display will return to the MAIN MENU screen.
1
2
PRE1-ALARM REC
REMAIN SHOTS: 6834
PRE1-ALARM REC
REMAIN SHOTS: 6834
NTSC
PA L
SETMENU
1 2
(MAIN MENU)
RECORD START
PLAYBACK
SETTINGS
CONDITION
MENU
SET
PRE1-ALARM REC
REMAIN SHOTS: 6834
PRE1-ALARM REC
REMAIN SHOTS: 6834
L42A4/US (DSR-C100) GB 2001, 4, 16
42 English