Filter
Top Products
PART NAMES AND FUNCTIONS
Front Panel Rear Panel
3 Camera mounting bracket
The camera mounting bracket is provided with
mounting holes (1/4” – 20 UNC). At the time of
shipment from the factory, the bracket is attached
to the top of the camera, but it can also be
attached to the bottom of the camera. Use
whichever attachment position is suitable for the
place and method of use.
Note: If installing the camera to a ceiling, always be
sure to check the strength of the installation
location (it must be able to bear a weight of at
least 10 kg). It is recommended that you use
the model VA-WH-1 mounting bracket (sold
separately) to install the camera. Contact the
place where you purchased the camera for
further details.
4 Caution indicator (See page 9)
Flashes or lights to indicate the operating status of
the camera.
5 Lens
6 Cooling fan
A cooling fan is provided in order to prevent the
inside of the camera from overheating.
If the cooling fan stops, stop the camera and check
the cause of the problem.
1 Control terminals
These terminals are used to connect extra items
such as hold-up and suspicion switches, a
warning indicator or a 13.8 V DC power supply.
2 RS-232C connector (RS-232C)
This connector is used to connect the camera to
a computer in order to transfer images from the
camera to the computer.
3 USB connector (USB)
This connector is used to connect a computer in
order to transfer images from the camera to the
computer.
If the RS-232C connector and USB connector
are both connected at the same time, the USB
connector has priority for image data transfer.
4 Rear cover fixing screw
This screw is used when replacing the hard disk
or the Ni-Cd backup battery.
Note: Never open the rear cover while power is
being supplied to the camera. Always be
sure to set the hard disk to standby mode
before opening the rear cover. (See page 11)
3
5
6
4
2
1
3
5
6
7
4
L42A4/US (DSR-C100) GB 2001, 4, 16
English 7