Filter
Top Products
Control terminals
5 VIDEO OUT terminal (BNC plug)
This terminal is used to connect the camera to a
component such as a monitor or camera control
unit.
6 RESET button
Press the RESET button if an abnormality occurs
with the camera. Settings are not changed
when the camera is reset in this way.
7 Warning indicator
•
The warning indicator lights when the
camera power is turned on.
•
It flashes when there is a hard disk error or if
there is a problem with the backup battery.
GND GND GND
WARNING
DC13.8V
H
S
1 2 3 4 5 6 7
Terminal Signal Input/output voltage
1 H (HOLD-UP) Alarm switch input signal 2.5 V or higher when alarm switch off/
0.4 V or lower when alarm switch on
2 GND Alarm switch and suspicion switch ground 0 V
3 S (SUSPICION) Suspicion switch input signal 2.5 V or higher when suspicion switch off/
0.4 V or lower when suspicion switch on
4 GND Warning ground 0 V
5 WARNING Warning signal output 3.3 V or higher when warning generated
6 GND Power supply ground 0 V
7 DC 13.8 V Power supply input 13.8 V DC
L42A4/US (DSR-C100) GB 2001, 4, 16
8 English