Filter
Top Products
113 English
EDITING VIDEO CLIPS
5 Specify the start point of the extract.
h Use the procedure below to specify the frame from which the video
clip extract will start.
h Play the video clip until approximately the desired point, pause the
video clip, then play the video clip one frame at a time, stopping at the
start point of the extract. This will be the first frame of the extract.
h If the start point of the video clip is also the start point of the extract,
proceed to step 6.
<Procedure>
Play:
After pausing playback, press and hold the [H] button for about
2 seconds for forward playback, or the [G] button for reverse
playback.
Pause:
During playback, press the SET button.
Accelerated playback:
During playback, press the [G] or [H] button to change the playback
speed.
Single frame:
After pausing playback, press the [H] button to move forward one
frame, or the [G] button to move back one frame.
6 Press the [T] button.
h The start point of the video clip
extract is set, and the screen to
specify the end point appears.
h Specify the end point of the extract
by following the same procedure as
in step 5.
<When joining the first and latter
portions>
1 Press the [W] button.
h Each time the [W] button is
pressed, the sections to delete
and the sections to save are
reversed.
2 Specify the end point of the
extract. The frame following the
end point of the extract will be the
start point of the latter portion to
be joined.
00:01:10
CUT
Press shutter to save
End point
Portion to be deleted
Approximate playback time