Filter
Top Products
27 English
INSTALLING THE BATTERY PACK AND CARD
Install the card
The card can be used after it has been formatted with the camera (page 145).
1 Open the battery/card
compartment cover.
2 Insert the card.
h Firmly insert the card until it clicks
into place.
3 Close the battery/card
compartment cover.
<When removing the card...>
h To remove the card, press it
down, and then release. The card
will protrude slightly, and you can
then pull it out.
CAUTION
Do not attempt to forcibly remove the card.
iNever remove the card when the multi-indicator is flashing red. In doing so,
you risk losing the data stored in the card.
HINT
Shooting without a card installed
iWhen a card is installed, images are recorded to and played back from the
card. When no card is installed, images are recorded to and played back
from the camera’s internal memory. When the camera is turned on with no
card installed, the internal memory icon is shown on the monitor to let
you know that the images you capture will be saved to the camera’s
internal memory.
1 Open
2 Insert
Card slot
1 Open
2 Push
3 Pull out