Sealife DC200 Digital Camera User Manual


 
iv
This camera is not waterproof or water resistant. Use the inner camera only inside the SeaLife waterproof
housing when in or around water. Follow waterproof housing instructions carefully to prevent water
damage to camera. Water damage to camera is not covered by warranty unless it has been determined
that the waterproof housing leaked water as a result of a manufacturing defect.
Do not use this camera if it is emitting smoke, emitting any unusual odor or noise, or if it is in any other
abnormal state. Operating the camera in any of these situations may cause a fire or an electrical shock.
Stop using the camera immediately, turn the camera off, and then disconnect the power source (batteries
or AC power adapter). (If you are using the AC power adapter, unplug the adapter from the AC power
outlet after you have disconnected the camera.) After checking that smoke is no longer being emitted,
contact your local authorized SeaLife service facility and request repairs. Never attempt to repair this
camera yourself as this is dangerous.
Do not use the camera if any water has entered the camera, even after camera has dried. Turn the camera
off, and then disconnect the power source (batteries or AC power adapter). (If you are using the AC power
adapter, unplug the adapter from the AC power outlet after you have disconnected the camera.) Then
contact your local SeaLife authorized service facility. Do not continue to use the camera as this may cause
a fire or an electrical shock. Be careful when handling wet camera. Camera and batteries may become very
hot.
Do not use the camera if any foreign objects have entered the camera. Turn the camera off, and then
disconnect the power source (batteries or AC power adapter). (If you are using the AC power adapter,
unplug the adapter from the AC power outlet after you have disconnected the camera.) Then contact your
local SeaLife authorized service facility. Do not continue to use the camera as this may cause a fire or an
electrical shock.
If the camera has been dropped or if the camera case has been damaged, turn the camera off, and then
disconnect the power source (batteries or AC power adapter). (If you are using the AC power adapter,
unplug the adapter from the AC power outlet after you have disconnected the camera.) Then contact your
local SeaLife authorized service facility. Do not continue to use the camera as this may cause a fire or an
electrical shock.
WARNING
PIONEERmanREV 11/19/01 6:00 PM Page iv