Filter
Top Products
22
Step 2: Charging the battery pack (Continued)
To remove the battery pack
1 Turn the POWER switch to OFF
(CHG).
2 Slide the BATT (battery) release lever
(1) and remove the battery pack (2).
b Notes
• When you remove the battery pack or the AC
Adaptor, make sure that the (Movie) lamp/
(Still) lamp (p. 25)/ACCESS lamp (p. 30)/
access lamp (p. 32) are turned off.
• When you store the battery pack, fully discharge
the battery before storing it for an extended
period (p. 119).
To use a power source from a wall
outlet (wall socket)
Make the same connections as you do when
charging the battery pack. The battery pack
will not lose its charge in this case.
To check the remaining battery
(Battery Info)
Set the POWER switch to OFF (CHG), then
press DISP/BATT INFO.
After a while, the approximate recordable
time and battery information appear for
about 7 seconds. You can view the battery
information for up to 20 seconds by
pressing DISP/BATT INFO again while the
information is displayed.
Charging time
Approximate time (min.) required when
you fully charge a fully discharged battery
pack.
Recording time
Approximate time (min.) available when
you use a fully charged battery pack.
When recording on the internal
memory (DCR-DVD810) or a
“Memory Stick PRO Duo”
DCR-DVD610
BATT (battery)
release lever
Battery pack Charging time
NP-FH40
(supplied)
125
NP-FH50 135
NP-FH70 170
NP-FH100 390
Battery pack
Continuous
recording
time
Typical
recording
time*
NP-FH40
(supplied)
110 50
120 55
NP-FH50 130 60
140 65
NP-FH70 280 130
300 140
NP-FH100 625 300
680 325
Remaining battery (approx.)
Recording capacity (approx.)