Filter
Top Products
26
b Notes
• If you do not use your camcorder for about 3
months, the built-in rechargeable battery gets
discharged and the date and time settings may
be cleared from the memory. In that case,
charge the built-in rechargeable battery and then
set the date and time again (p.124).
• It takes a few seconds for your camcorder to be
ready to shoot after the power is turned on. You
cannot operate your camcorder during this time.
• In the default setting, the power turns off
automatically if you leave your camcorder
unoperated for approximately 5 minutes, to save
battery power ([A.SHUT OFF], p. 89).
z Tips
• The date and time does not appear during
recording, but they are automatically recorded
on the media, and can be displayed during
playback ([DATA CODE], p. 84).
• See page 115 for information concerning
“World time difference.”
• If the buttons on the touch panel do not work
correctly, adjust the touch panel
([CALIBRATION], p. 122).
You can change the on-screen displays to
show messages in a specified language.
Touch (HOME)
t (SETTINGS)
t [CLOCK/ LANG] t
[ LANGUAGE SET], then select the
desired language.
Changing the language setting
Step 4: Making
adjustments before
recording
Slide the LENS COVER switch to OPEN.
After recording, set the LENS COVER
switch to CLOSE to close the lens cover.
Open the LCD panel 90 degrees to the
camcorder (1), then rotate it to the best
angle to record or play (2).
To turn off the LCD backlight to make
the battery last longer
(DCR-DVD710/DVD810)
Press and hold DISP/BATT INFO for a few
seconds until appears.
This setting is practical when you use your
camcorder in bright conditions or you want
Opening the lens cover
Adjusting the LCD panel
190 degrees to the
camcorder
2180 degrees
(max.)
290 degrees
(max.)
DISP/BATT INFO
Step 3: Turning the power on, and
setting the date and time (Continued)