Filter
Top Products
GB
6 Precautions
Precautions
This Sony product has been designed with
safety in mind. However, if not used
properly electrical products can cause fires
which may lead to serious body injury.
To avoid such accidents, be sure to heed the
following.
Heed the safety precautions
Be sure to follow the general safety
precautions, and the “Operating
Precautions.”
In case of a breakdown
In case of a system breakdown, discontinue
use and contact your authorized Sony dealer.
In case of abnormal operation
• If the unit emits smoke or an unusual
smell,
• If water or other foreign objects enter the
cabinet, or
• If you drop the unit or damage the cabinet:
1 Disconnect the camera cable and the
connecting cables.
2 Contact your authorized Sony dealer or
the store where you purchased the
product.
Operating or storage location
Avoid shooting very bright objects (such as
light fittings or sunlight) for an extended
period. Avoid operating or storing the unit in
the following locations:
• Extremely hot or cold places (operating
temperature: –10 °C to +50 °C
(–4 °F to 122 °F))
• Close to sources of powerful
electromagnetic radiation, such as radios
or TV transmitters
• Close to excessively dusty places
• Where exposed to mechanical vibrations
• Close to fluorescent lamps or objects
reflecting light
• Under unstable light sources (it may cause
flickering)
• Close to sources of strong magnetism
Attaching the dome casing
Attach the dome casing securely with the
supplied wrench.
Cleaning
• The dome cover is the optical part. Use a
soft, dry cloth to remove the fingerprints
or dust.
• Use a blower to remove dust from the lens.
• Clean the body with a dry soft cloth. If it is
very dirty, use a cloth dampened with a
small quantity of neutral detergent, then
wipe dry.
• Do not use volatile solvents such as
alcohol, benzene or thinners as they may
damage the surface finishes.
Using the camera outdoors
Make sure that the waterproof rubber gasket
of the dome casing is put in place, and attach
the dome casing securely to the unit casing.
Make sure you seal the locations listed
below with sealant (e.g. silicon sealant) to
prevent moisture from getting inside the
casing.
• Camera installation holes (4)
• Conduit holes (side/bottom)
Operating Precautions