Filter
Top Products
13
GB
Location and Functions of Parts and Controls
Overview
r VIDEO OUT (Video out)
connector
Connect the BNC cable to this
connector.
s AC/DC IN (power input)
connector
Connect an 24V AC/12V DC cable to
this connector.
t Unit casing
The unit casing is made of die-cast
aluminum and has conduit holes on the
side and at the bottom.
u Dome casing
The dome cover is made of
polycarbonate. A waterproof rubber
gasket is provided on the joint surface to
the unit casing.
v Safety cord
This cord prevents the dome casing from
falling off the unit casing. Make sure
that the cord does not get caught
between the dome casing and the unit
casing. Rotate the cord and adjust the
position of the cord.
w Reset switch
To reset the camera to the factory default
settings, hold down this switch and
supply the power to the camera.
x Screw for drop-prevention rope
(Bottom)
y Camera installation holes (4
positions)
Make sure to tighten the screws securely
when installing the camera.
z Pan angle adjustment screw
Loosen this screw before adjusting the
lens position, then tighten it to lock in
the lens position.
wj Slit cover screws (2 positions)
wk Dome case screw hole (3
positions)
This is a ground terminal for the chassis.
U
P
wg
wh
wj
w
k