Filter
Top Products
105
GB
Advanced Operations Miscellaneous
continued on next page
7 Insert the DC power cable connector v mark side
first into the battery case until it locks firmly into
place.
8 Put the cable into the battery cover groove and
close the battery cover.
Connecting to the PC
If the camera and the PC are connected using the PC interface cable (supplied), pictures stored on the
PC card can be read by the PC and you can operate the camera from the PC.
Note
• Before connecting the camera to the PC, please install the following hardware and
software:
– An IEEE1394 PCI board that conforms to OHCI standards (recommended: RATOC
Systems, Inc. model type: RATOC-PCIFW1).
– TWAIN driver software for Windows98 (supplied)
Please refer to ReadMe on the driver setup CD-ROM for necessary system
settings, installation procedures, and how to operate the TWAIN driver software.
• If the battery is disconnected during PC communication, images you have taken
may be lost. When connecting to the PC, plug the AC adaptor/charger AC-VQ800
(supplied) into a wall socket.
• Place the card in the camera. Images are stored on the card even in PC mode.
• Please note that the camera may not work properly if it is connected through the
standard 1394 (or 1394-compatible) interface that is provided with your computer.
IS
O
USER
S
IZ
E
QUAL
DRIVE
W
B
AE
A
F
M
REMOTE
VIDEO
OUT
PC
1 Connect the camera’s PC interface terminal and
the PC’s IEEE1394 terminal using the PC
interface cable (supplied).
7
1