Filter
Top Products
19
Getting started
Using an external power source
,
Open the DC IN jack cover,
then connect the AC-LS1 AC
power adaptor (not supplied)
to the DC IN jack of the camera.
Connect the cable with the v mark facing
up.
•
Connect the AC power adaptor to an easily
accessible wall outlet (mains) close by. If
something goes wrong while you are using the
adaptor, immediately shut off the power by
pulling the plug out of the wall outlet.
1
DC IN jack
cover
DC plug
AC power adaptor
(not supplied)
,
Connect the power cord (mains
lead) to the AC power adaptor
and to the wall outlet (mains).
•
When you have finished using the AC power
adaptor, disconnect it from the DC IN jack of
the camera.
•
To use power from an automobile, use a DC
adaptor/Charger (not supplied).
•
If you insert or remove the DC plug while you
are using the batteries, the power may shut off.
2
2 To the wall outlet (mains
)
Power cord
(mains lead)
1
Using your camera
abroad
Power sources
You can use your camera in any country or
area with the supplied battery charger or the
AC-LS1 AC power adaptor (not supplied)
within 100 V to 240 V AC, 50/60 Hz. Use a
commercially available AC plug adaptor
[a], if necessary, depending on the design of
the wall outlet (wall socket) [b].
• Do not use an electronic transformer.
Using this may cause a malfunction.
BC-CS1