Filter
Top Products
22
Step 2: Charging the battery pack (Continued)
To remove the battery pack
1 Slide the POWER switch to OFF
(CHG).
2 Raise the viewfinder.
3 Press the BATT (battery release) button
and remove the battery pack.
b Notes
• When you remove the battery pack or the AC
Adaptor, make sure that the (Movie) lamp/
(Still) lamp (p. 24) is turned off.
When storing the battery pack
Fully discharge the battery before storing it
for an extended period (see page 109 for the
details of storage).
To use an outside power source
Make the same connections as you do when
charging the battery pack. The battery pack
will not lose its charge in this case.
To check the remaining battery
(Battery Info)
Set the POWER switch to OFF (CHG), then
press DISP/BATT INFO.
After a while, the approximate recordable
time and battery information appear for
about 7 seconds. You can view the battery
information for up to 20 seconds by
pressing DISP/BATT INFO again while the
information is displayed.
Charging time
Approximate time (min.) required when
you fully charge a fully discharged battery
pack.
Recording time
Approximate time (min.) available when
you use a fully charged battery pack.
HDR-UX5
Battery pack Charging time
NP-FH50 135
NP-FH60 (supplied with
HDR-UX5)
135
NP-FH70 (supplied with
HDR-UX7)
170
NP-FH100 390
Battery pack
Continuous
recording
time
Typical
recording
time*
Image
quality
**
HD SD HD SD
NP-FH50 60 70 30 35
60 75 30 35
60 75 30 35
NP-FH60
(supplied)
75 95 35 45
75 100 35 50
90 100 45 50
Remaining battery (approx.)
Recording capacity (approx.)