Filter
Top Products
92
Troubleshooting (Continued)
Even if you press EASY, menu
settings do not switch to their
defaults automatically.
• Following menu settings remain as they
were set even during Easy Handycam
operation.
– [FILE NO.]
– [VOLUME]
–[TV TYPE]
– [ DISPLAY]
–[BEEP]
– [SUB-T DATE]
– [CLOCK SET]
– [AREA SET]
– [DST SET]/[SUMMERTIME]
– [ LANGUAGE SET]
– [ IMAGE SIZE]
– [WIDE SELECT]
– [COMPONENT]
– [DEMO MODE]
– [DIAL SETTING] (HDR-UX7)
– [TIMING] and [RECORD SOUND] in
[SMTH SLW REC]
– [X.V.COLOR]
Your camcorder vibrates.
• Vibration occurs depending on the
condition of the disc. This is not a
malfunction.
A vibration is felt in your hand or a
faint sound is heard during
operation.
• This is not a malfunction.
A motor sound is heard in the
camcorder when the disc cover is
closed without a disc.
• Your camcorder is trying to recognize the
disc. This is not a malfunction.
Your camcorder gets warm.
• This is because the power has been turned
on for a long time. This is not a
malfunction. Turn off your camcorder and
leave it for a while in a cool place.
The supplied Remote Commander
does not function.
• Set [REMOTE CTRL] to [ON] (p. 78).
• Insert a battery into the battery holder with
the +/– polarities correctly matching the +/
– marks (p. 121).
• Remove any obstructions between the
Remote Commander and the remote
sensor.
• Point the remote sensor away from strong
light sources such as direct sunlight or
overhead lighting. Otherwise, the Remote
Commander may not function properly.
Another DVD device malfunctions
when you use the supplied Remote
Commander.
• Select a commander mode other than DVD
2 for your DVD device, or cover the sensor
of your DVD device with black paper.
The power abruptly turns off.
• When approximately 5 minutes have
elapsed while you do not operate your
camcorder, the camcorder is automatically
turned off (A.SHUT OFF). Change the
setting of [A.SHUT OFF] (p. 78), or turn
on the power again, or use the AC Adaptor.
• Charge the battery pack (p. 21).
The CHG (charge) lamp does not
light while the battery pack is being
charged.
• Slide the POWER switch to OFF (CHG)
(p. 21).
• Attach the battery pack to the camcorder
correctly (p. 21).
• Connect the power cord to the wall outlet
properly.
• The battery charge is completed (p. 21).
The CHG (charge) lamp flashes while
the battery pack is being charged.
Batteries/Power sources