Sony SNC-DH210T Security Camera User Manual


 
Administrating the Camera
Using the 802.1X Authentication Function — 802.1X Menu
54
Using the 802.1X
Authentication Function
— 802.1X Menu
When you click in the Administrator menu, the
802.1X menu appears.
Use this menu to configure the wired port-based
authentication in compliance with the 802.1X standard.
The 802.1X menu consists of three tabs: Common,
Client certificate and CA certificate.
Notes
To use the 802.1X authentication function, you need
knowledge of the 802.1X authentication (WPA and
WPA2) and digital certificate. To establish an 802.1X
network, you need to configure the authenticator,
authentication server and other elements. For details
on these settings, refer to the manual of the
corresponding equipment.
When using the 802.1X authentication function,
always configure the settings after setting the date and
time of the camera. If the date and time are incorrect,
port authentication may not be performed correctly.
System configuration of 802.1X
network
The following figure shows a general system
configuration of an 802.1X network.
Supplicant
A supplicant is a device that connects to the
authentication server to join the network. This unit
serves as a supplicant in the 802.1X network. The
supplicant can enter the 802.1X network after
appropriate authentication by the authentication server.
Authenticator
An authenticator forwards certificate request data or
response data that the supplicant or authentication server
issues to the other party. Normally a hub or router serves
as an authenticator.
Authentication server
An authentication server has a database of connected
users and verifies if the supplicant is a valid user or not.
It can also be called RADIUS server.
CA (Certificate Authority)
A CA issues and manages certificates of the
authentication server (CA certificates) and user
certificates. The CA is essential for certificate-based
user authentication. Normally a CA is located inside an
authentication server.
Note
This camera supports EAP mode in which the supplicant
and the server authenticate using the certificate. This
mode requires a CA to issue the certificate.
Common Tab — Basic setting of
802.1X authentication function
802.1X authentication function
This item is used for enabling/disabling the 802.1X
authentication function for wired ports. The wired
interface status can also be checked here.
Wired interface
To activate the 802.1X authentication function for wired
ports, select On.
802.1X
Supplicant (camera)
Authenticator
(hub or router)
Authentication server + CA