Filter
Top Products
Getting started
16
Step 2: Charging the
battery pack
You can charge the battery by attaching the
“InfoLITHIUM” battery pack (F series) to
your camcorder.
b Note
• You cannot use batteries other than the
“InfoLITHIUM” battery pack (F series) (p. 130).
• Do not short-circuit the DC plug of the AC Adaptor
or battery terminals with any metallic objects. This
may cause a malfunction.
• Use a nearby wall socket when using the AC
Adaptor. Disconnect the AC Adaptor from the wall
socket immediately if any malfunction occurs.
1 Attach the charged battery pack to the
camcorder.
1 Slide the BATT (battery release)
lever in the direction of 1 and push it
down in the direction of 2.
Remove the battery terminal cover when
it lifts up in the direction of 3.
2 Attach the battery pack with its terminal
side facing your camcorder as shown in
the following illustration and press down
the battery pack until it clicks.
2 With the v mark on the DC plug facing
up, connect the AC Adaptor to the DC
IN jack on the Handycam Station.
3 Connect the mains lead to the AC
Adaptor.
4 Connect the mains lead to the wall
socket.
To the wall socket
DC plug
Mains lead
AC Adaptor
DC IN jack
Handycam Station
BATT (battery release) lever
v mark
DC IN jack