Filter
Top Products
© Copyright 2012 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TV-IP322P
31
Event Configuration >> Schedule Trigger
You can separately configure the schedule for trigger function of the camera by
Email, FTP, or Network Storage. Select the Enable option on each item, and then
select a Schedule Profile from the pull-down list and set the Interval time.
NOTE If the setting value of the Network Storage Recording Time Per Event option
in General Setting is longer than the Interval time in Network Storage
Schedule, the recorded file will be a continuous video clip.
For example, if you set the Network Storage Recording Time Per Event as
10 seconds and the Interval as 5 seconds, recorded file becomes a non-stop
video clip because the camera will record a 10-second video clip every 5
seconds.
Event Configuration >> GPIO Trigger
GPIO Trigger: Select the Enable Trigger In 1/2 option to enable the GPIO trigger
function of the camera, so that you can set Trigger Out function or send
captured images within the detecting area to the SD card, FTP server, email
receiver, Network Storage server, or send an instant message. Event server has
to be configured prior to using the functions.
- Schedule Profile: Select a schedule profile from the pull-down list.
- Action: Set the Trigger Out function or select the destination that the
captured images will be sent to: Record to SD Card, Record to Network
Storage, Send Email, FTP Upload, or Instant Message.