© Copyright 2012 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TV-IP322P
40
5. Go to Virtual Server* section and create a new entry.
Enable: Click Enable
Name: Enter the application name (eg. Camera Name)
Protocol: Select TCP
Private Port: The HTTP port that you assign on your Camera.
Public Port: The port used on remote side to access to your Camera.
LAN Server: The local IP address of your Camera.
Click Add to add the application.
* Please refer to your router’s user’s manual for detail Virtual Server setting.
Some router might use Port Forwarding or Special applications for this
function. The setup steps should be very similar.
6. Open another web browser and enter your DDNS domain and camera’s port
number.
http://yourDomainName:PortNumber
7. The camera login page will appear.
Technical Specifications
Camera
General Sensor: 1/3” Megapixels color CMOS sensor
Resolution: 1280 x 1024 pixels
Board Lens
Focal Length: 12mm
Aperture (F/No): F1.8
Minimum illumination: 0 Lux (Night vision)
Viewing Angle :
Diagonal: 28.5 degree
Horizontal: 22.7 degree
Vertical : 17.2 degree
Image & Video Compression: H.264, MPEG-4, and MJPEG
Exposure/white balance/gain control : automatic
Built-in ICR
Audio
External microphone in
Sensitivity: -48dB +/- 3dB
Frequency:50~16000Hz
S/N: >60dB
Format: PCM/AMR
Pan/Tilt/Zoom Protocol: Pelco D, Pelco P
32 presets
Auto Patrol
GPIO Ground, GPIO in/out, RS485, 12V DC, 24V AC
SD Slot Supports SD/SDHC (up to 32GB)
Hardware
Network
IEEE 802.3u 10/100Mbps Fast Ethernet
IEEE 802.3af PoE