Filter
Top Products
TV-IP512P ProView PoE Internet Camera
13
Reset Camera
A manual reset can be conducted by following the procedure below. The reset button is located on
the rear panel of the camera. To reset the system settings to factory defaults, please follow these
steps:
1. Leave the camera powered on, do not disconnect the power.
2. Use a paper clip or similar object to press the reset button and hold. The reset button is
located on the rear panel of the device. See the Rear Panel Components picture above to
locate the reset button.
3. Keep the button pressed about 10 seconds.
4. Release the button.
The camera will then automatically reboot itself. Upon restarting the camera loads the factory
default configuration settings. The default IP address 192.168.10.30 and subnet mask
255.255.255.0 will be applied unless a DHCP server is actively connected to the network. The
administrator’s default user name is admin and the password is admin. Use the SetupWizard
shipped with the camera to reconfigure it or access it through the web-based management
software.
SD Card Slot
SD Card Slot
The built in SD card slot allows you to insert Secure Digital Cards. This
enables images taken by the camera to be saved to an external SD card.
SD Card Slot